-
-
Very Active Member
-
I don't want to find out the HARD way, that it couldn't be read... BarneyFife.jpg
-
Very Active Member
I have mine right on the frunk hood, inside. If your doesn't read where you want to put it, they just send you a notice and then you give them the account info. Thats what they do in NJ anyway....
Rewaco RF-1 GT
Inline 4 cylinder Ford Zetec with multi-port fuel inject, 140 HP
0-60mph: 5.8 seconds
5 speed sync manual with reverse, mechanical dry clutch.
Front suspension: Trapezoidal fork with center spring
Rear suspension: Independent with Bilstein gas shock absorbers
Brake System: Grimeca calipers, linked ventilated discs, with booster
10.57 gallons
-
Very Active Member
We've got a few roads that use the E-Z Pass around these parts. The Dulles Toll Road can *usually* read my pass in the frunk, but the Dulles Greenway can't at all (and there are no speed lanes-- you have to stop and pay if it doesn't read). I've got a velcro spot underneath my Madstad mounting plate that I've used that works better, but the metal plate still blocks it from time to time.
I think the next spot for my pass is the back of my Ultimate Seat driver's backrest-- I bought the little zip-pocket when I got the seat, but never felt comfortable putting anything valuable in it. That's probably a perfect place for the pass.
(Obviously, doesn't help my RT brothers & sisters, but figured I'd share for the RS readers in the crowd!).
Silver 2010 RS SE5: Triple Play, Taillight, Brightsides, Fender Tips, Easy Risers; Evo Sway Bar; Airhawk R & Beadrider; latch springs; Grab-On grips; Crampbuster; 24" Madstad smoke windshield & deflectors; N-R round bag & soft saddlebags; BRP handlebar bag; Throttlemeister; Spyderpops Missing Air Dam & Air Mgmt System; Rivco driver & passenger boards & pegs; ISCI parking brake extension; Ultimate Midrider Seat w/both backrests, Fox Racing Shocks, Yoshi R-77 exhaust and a whole lotta love!
-
Very Active Member
Originally Posted by spyder3
I have mine right on the frunk hood, inside. If your doesn't read where you want to put it, they just send you a notice and then you give them the account info. Thats what they do in NJ anyway....
Same here, on the inside of frunk lid and they have your plate if it doesn't read.
If your plate is in the system there shouldn't be any extra charge.
-
Last edited by Bob Denman; 04-28-2014 at 04:01 PM.
-
Very Active Member
You can get extra Velcro and make it stay on the lid.
Just thinking it would be out of your way there.
-
Registered Users
Bob, do you have a dash pouch? I would think that a dash pouch would be ideal for placing the e-z-pass. I am thinking about a 3 compartment dash pouch to place my carry in while ryding.
Good Luck with your decision.. as always.. *Cognac Up.. .. Drink*
2014 RT S SE-6 Cognac, 2014 Indian Chieftain. Retired Navy Chief
-
Very Active Member
Originally Posted by Bob Denman
Well; I just got a packet in the mail with these E-ZPass doodads...
The Cages; I've got figured out: stick them up on the dash right where it makes it impossible to access the registration and inspection stickers...
But the RT...
I opened up the frunk, and found a flat wall behind the zipper that gives me battery access; Can it be read by the scanners through all of that cloth and plastic? It seems like a GREAT spot; it's protected, and out of the way!
Or is it just too good to be true?
Put it inside the lid of the frunk. Works Great the, & no worries about it getting stolen.WP_000088.jpg
"A Wise Man Once Said, I Should Ask My Wife."
2017 Champagne Metallic RT-S SE-6 Rivco Dual Flag Holders; Slingmods Highway Pegs; (Hate Them) Airhawk Seat Cushion; Show Chrome Black Touring Rack w/ Risers & Touring Windshield; RAM X Mount For TXTAG; TackForm Phone Mount; Lidlox; Magic Mirror Mounts; Guardian Bells; WOLO "Bad Boy" Air Horn; Dual USB Power Outlet With Voltmeter; 12V outlet for misc. stuff; Spyderpops Full View Mirror Turn Signals; Large Brake Pedal; Kott Grilles; Large Mud Flap; BajaRon 3 Piece Sway Bar, Last But Not Least, Kuhmo Rear Rire, Vedrestien Fronts.
2017 RT-S , Brake pedal extender is twice the size of the stock pedal. Champagne Metallic
-
Registered Users
Originally Posted by Bob Denman
that was my first choice.
But the velcro wasn't holding when I dorpped the lid, and I was concerned about artlcles in the Frunk knocking it loose! I'll see if I can pop a picture of where i've hidden the darn thing...
Industrial strength Velcro should hold it in place.
If you ryde like there's no tomorrow, there won't be any
Accidents hurt - safety doesn't
-
Originally Posted by oldguyinCT
Put it inside the lid of the frunk. Works Great the, & no worries about it getting stolen. WP_000088.jpg
The picture says it all... Thanks!
I've currently got minebehind the zippered "Trap Door", that lets you get to the Battery. I THOUGHT that'd be a great place, since it can't get hit by anything that's in the frunk, and I seem to aways need just about every cubic inch of space that I can muster up!
-
Very Active Member
Originally Posted by Bob Denman
that was my first choice.
But the velcro wasn't holding when I dropped the lid, and I was concerned about artlcles in the Frunk knocking it loose! I'll see if I can pop a picture of where I've hidden the darn thing...
The "velcro" that came with mine is a rigid plastic that requires a firm push to engage with it's mate. Also, it was mentioned to me to install so the label faced the rear of the bike, or in other words, the "velcro" side is towards the front.
2016 RT-S Special Series
-
Velcro side forward? nobody mentioned that; thanks!
-
Active Member
Originally Posted by oldguyinCT
Put it inside the lid of the frunk. Works Great the, & no worries about it getting stolen. WP_000088.jpg
Ours has been in same spot for over a year. Works great. Stock mounting Velcro in NJ is very aggressive and unit never has come loose slamming the trunk .
Last edited by Raknid; 04-29-2014 at 05:44 PM.
-
magical member
I have mine in the frunk behind the frunk liner just above the manual and cd holder. Never had an issue with it reading. Not worried if it didn't read the odd time has they just read your plate and match up in the system anyway.
harry
"Draco dormiens nunquam titillandus"
My Rides;
Nimbus 2000, Ford Anglia, 2012 Spyder RT Limited, Pre 14 Vintage Classic Collectors Edition!
Favorite Ride;
Nimbus 2000 boy this thing can fly.
Mods:
Charm of invisibility, Reparo Charm (cuts down on service cost)
One always wonders about roads not taken.
-
Harry,
That exactly the location that I'm the most interested in...Thanks!
-
Very Active Member
when pulling a trailer do you still go thru the ezypass fast lane ???
-
Active Member
Originally Posted by harrypottar
I have mine in the frunk behind the frunk liner just above the manual and cd holder. Never had an issue with it reading. Not worried if it didn't read the odd time has they just read your plate and match up in the system anyway.
harry
I was just discussing this with a friend yesterday. He puts it in the lower center of his w/s. He has had problems in the frunk when he has the luggage there.
2014 RT Limited Black Currant, BaJaRon Anti-Sway Bar and Links, Show Chrome Luggage Rack, Rivco Trunk Mounted Double Flag Holder. More to Come.
08 Honda Aero - wife's
14 Kymco - wife's (Hmmmmm...i'm losing bikes)
-
Very Active Member
Originally Posted by mastertek2000
when pulling a trailer do you still go thru the ezypass fast lane ???
I did last summer on the Garden State Parkway in NJ (both directions) and at the Tappan Zee Bridge in NY. In NJ, the tolls are higher because they charge by the number of axles. Other states may do the same.
"A Wise Man Once Said, I Should Ask My Wife."
2017 Champagne Metallic RT-S SE-6 Rivco Dual Flag Holders; Slingmods Highway Pegs; (Hate Them) Airhawk Seat Cushion; Show Chrome Black Touring Rack w/ Risers & Touring Windshield; RAM X Mount For TXTAG; TackForm Phone Mount; Lidlox; Magic Mirror Mounts; Guardian Bells; WOLO "Bad Boy" Air Horn; Dual USB Power Outlet With Voltmeter; 12V outlet for misc. stuff; Spyderpops Full View Mirror Turn Signals; Large Brake Pedal; Kott Grilles; Large Mud Flap; BajaRon 3 Piece Sway Bar, Last But Not Least, Kuhmo Rear Rire, Vedrestien Fronts.
2017 RT-S , Brake pedal extender is twice the size of the stock pedal. Champagne Metallic
-
Active Member
I tried to add the Spyder. I put it as Other for Make and Other for Model. No Can Am listing.
Did ya'll do the same?
2014 RT Limited Black Currant, BaJaRon Anti-Sway Bar and Links, Show Chrome Luggage Rack, Rivco Trunk Mounted Double Flag Holder. More to Come.
08 Honda Aero - wife's
14 Kymco - wife's (Hmmmmm...i'm losing bikes)
-
Very Active Member
In our listings in Va. we have motorcycle.
-
Originally Posted by Vidman
I tried to add the Spyder. I put it as Other for Make and Other for Model. No Can Am listing.
Did ya'll do the same?
I had the same problem...
I think that I plugged in "Other", and then Can Am Spyder in the model field...
-
I just put mine in my jacket or vest
I just put my EZ Pass in my left vest pocket. It reads fine as I ride through. Never had an issue.
Doc
Originally Posted by Bob Denman
Well; I just got a packet in the mail with these E-ZPass doodads...
The Cages; I've got figured out: stick them up on the dash right where it makes it impossible to access the registration and inspection stickers...
But the RT...
I opened up the frunk, and found a flat wall behind the zipper that gives me battery access; Can it be read by the scanners through all of that cloth and plastic? It seems like a GREAT spot; it's protected, and out of the way!
Or is it just too good to be true?
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|