Look great! I have the LED's on my 2011 RS-S on the splash panel like yours. They work when car or truck is behind me, when I hit the brakes they back off.
Do these run while the bike is started then brighten when the brake has been pressed? Which wires did you tap into?
I had the fender light wire to work with because I removed the fender!
You basically use posi taps to tap into a Black wire (Under Back) for ground, orange wire for running and white wire for Brake.
Tric Leds (Vendor on Home page) has a kit with the lights on the side of the wheel cover thats plug and play and act as (Dual Intensity) Running and Brake. I would have bought those if I didn,t already have the side lights and then I would Not have had to add the MegaLight LEDS you see under when the brake is applied. Check them out at Tricled?
I did the same setup on my RSS. I bought a 16 foot roll of led strip from Hitlights for about 20 bucks. With the clip they sell I cut 2 strips one on each side from where the side tupper ware starts to the Tail. I have a Bestem trunk which I removed the reflector and installed a double strip of leds there. I still have 2 feet left over.