-
Registered Users
trying to install easy risers Help!
Well I seem to be in a jam, thought I could follow simple instructions. I have the grips off and controls both sides. I have free'd up as much slack as possible. Cut the bar on the left side funny thing the spot to cut was right in the middle of the slot in the old bar. made it difficult to cut and get riser onto. I have the riser on with the new bar segment trying to put the controls on (SE5 I might add) instructions say there's a pin that has to go into the hole in the bar. Unless I dropped something and lost it I don't see any pin or whatever is supposed to go into that slot. Don't have a shop manual so before you suggest that, forget it. I may have bitten off more than I can chew
MY RIDE - 2011 RSS SE5 Alloy Orange/Matte Black
MY MODS - Yoshimura Exhaust, BRP Comfort Seat, Fog Lights, Battery Tender, 4.5" Easy Risers, Kuryaken Iso Grips, Cal Sci XL Windshield, Cruise-mate Throttle Lock, Green Air Filter, O2 modifier, Weaver Floorboards, Baja Ron's Anti-Sway Bar, Smoothspyder Adjustable Backrest, Center LED Tail Light and Magic Brake Flasher.
-
Very Active Member
THAT PIN
Last edited by BLUEKNIGHT911; 09-28-2012 at 06:34 PM.
-
Registered Users
OK thanks I think I got licked now. had to turn the dog bone around the opposite way from the instructions to make the cables all lay right. Actually i think it looks more natural with the bend down instead of up but anyway... plenty of slack now I have to put the new grips on I got the black iso grips with throttle boss from kuryaken any special advise for that? Ive never installed grips before either (sad I know). looks like I'll be finishing up in the morning ran out of daylight and there's no light in the carport.
MY RIDE - 2011 RSS SE5 Alloy Orange/Matte Black
MY MODS - Yoshimura Exhaust, BRP Comfort Seat, Fog Lights, Battery Tender, 4.5" Easy Risers, Kuryaken Iso Grips, Cal Sci XL Windshield, Cruise-mate Throttle Lock, Green Air Filter, O2 modifier, Weaver Floorboards, Baja Ron's Anti-Sway Bar, Smoothspyder Adjustable Backrest, Center LED Tail Light and Magic Brake Flasher.
-
Very Active Member
GRIPS
I just use spit and no glue.....after it evaporates...and it will.... they won't move unless you have to get them off........it helps to twist while putting the left one on......the right (throttle) one is different just push straight in......good luck......Mike
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|