-
Active Member
Is there any kind of mod to.....
Is there a mod to block off the space that is between your outer tupperware and the inner body panel on each side. Seems like I get a lot of heat coming up through that crack on both sides (along with a little exhaust smell). When I bought my Spyder the guy that owned it had made one out of muffler wrap and a silver heat shield. He painted the silver heat shield black but the heat was causing the paint to flake off and it looked terrible so I took it off. Didn't know if there was something out there to buy to solve this problem. Thanks!
-
Motorbike Professor
Click on the SpyderPops ad on the home page. He has just what you need.
-Scotty
2011 Spyder RTS-SM5 (mine)
2000 BMW R1100RTP, motorized tricycle & 23 vintage bikes
2011 RT-622 trailer, Aspen Sentry popup camper, custom motorcycle trailer to pull behind the Spyder
Mutant Trikes Forever!
-
Active Member
Looked but didn't see anything. I have the air dam and heat shield. The space I am referring to is the space you see when you look down if you sitting on the bike between my red panel and black panel on each side of the bike.
-
Very Active Member
BLOCKING OFF THAT SPACE
Originally Posted by Spyderrx
Is there a mod to block off the space that is between your outer tupperware and the inner body panel on each side. Seems like I get a lot of heat coming up through that crack on both sides (along with a little exhaust smell). When I bought my Spyder the guy that owned it had made one out of muffler wrap and a silver heat shield. He painted the silver heat shield black but the heat was causing the paint to flake off and it looked terrible so I took it off. Didn't know if there was something out there to buy to solve this problem. Thanks!
If it's the space I'm thinking of if it was my Spyder I wouldn't. It is already way to hot in the engine compartment now. If you block off those vents you may have some serious overheating problems. I have an 08 GS and I don't think there is very much heat coming out of the upper vents......JIMHO...Mike......PS We all don't have crystal balls so letting people know what type of Spyder you have is usually very helpful....ther is more than one type
Last edited by BLUEKNIGHT911; 08-27-2012 at 10:56 PM.
-
Active Member
-
Motorbike Professor
If you have excessive heat coming out that high on an RS, you probably need to replace the exhaust Y-pipe gaskets. Use the Honda gaskets, they last longer.
-Scotty
2011 Spyder RTS-SM5 (mine)
2000 BMW R1100RTP, motorized tricycle & 23 vintage bikes
2011 RT-622 trailer, Aspen Sentry popup camper, custom motorcycle trailer to pull behind the Spyder
Mutant Trikes Forever!
-
Do the GS/RS models have those panels that run underneath the bike? Removing them might also give the hot air more avenues from which to vacate the premises...
-
Very Active Member
I will be using my trailer with the RT for the 1st time tomorrow when we leave Northern Michigan en route to Florida via Lamonsters.The RT fits perfectly in the trailer and thanks to the various posts above confirms the way I intended to ratchet it down.I previously used the same trailer to tow my Goldwing.
Ivor
-
-
Very Active Member
i wraped my header pipes,and took off the bottem plates,and allthe spyder pops help and have no proublem with heat,
-
Registered Users
2009 Red & Black RS
Mods so far:
Ultimate Seat w/Backrest
Kewl Metal Highway Brackets
-
Active Member
I need to check out the bottom plates
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|