2023 F3-T Limp home mode/check engine light- any ideas?

[Pikester]

Hey everyone, I washed my Spyder this morning, no high pressure, was riding home, tried to set the cruise while going about 25 and the bike immediately went into limp mode and check engine light is flashing. I rode home with no issues, was installing a new horn, so the battery was disconnected for a couple of hours. Started the bike up, no check engine, started riding, went about a 1/4 mile and it went back into limp mode. I plan on setting up an appointment, but figured I would see if anyone had any suggestions. I have approximately 1700 miles. Thanks

[Pikester]

Okay, so I checked my Pedal Commander and even though it is in the water resistant cover, there was quite a bit of moisture inside the cover. I disconnected the battery and the PC, hooked everything back up stock and everything is back to normal.

[VitoNam]

It's always good to hear what the solutions are to problems. Thanks!

[Dasmoetorhead]

Okay, so I checked my Pedal Commander and even though it is in the water resistant cover, there was quite a bit of moisture inside the cover. I disconnected the battery and the PC, hooked everything back up stock and everything is back to normal.

Glad, you found the problem, and got it resolved quick.
Where did you have the PC mounted?

[Pikester]

Glad, you found the problem, and got it resolved quick.
Where did you have the PC mounted?

It was mounted on the inside of the side cover, but the adhesive didn’t hold and it was dangling right above the bottom of the cover.

[Dasmoetorhead]

Ok, thanks.