-
Very Active Member
What Type Gerbing Hookup is needed for '22 RT?
I use this type Coax Jack (https://www.thewarmingstore.com/warm...lug-cable.html) on my F3T which is now being traded on a '22 RT. Is this hookup also ideal for the RT, or is there something else more suitable? I don't yet have the RT; just getting prepared in advance.
I want it to be hooked direct to the battery so that it can also be used to connect a battery tender.
Last edited by Peter Aawen; 03-17-2023 at 04:48 PM.
Reason: Removed Prefix - this is not a HowTo: DIY thread... ;-)
Two Wheelers from 1963-2011
Three Wheelers:
2011 RT(Red)
2014 RT(white)
2016 F3T(red)
2022 RT current ride(silver)
__________________
2016 Slingshot
2018 Vanderhall
2019 Slingshot
-
Very Active Member
If it worked on the F3 it will be fine on the RT. I have that setup on our 2015 RT for both my wife and I to run heated gear. I use an accessory fuse block instead of going directly to the battery, but to each his own. Use whatever works for you.
Last edited by Peter Aawen; 03-18-2023 at 07:31 AM.
Reason: Sp ;-)
-
i use the california heat 12v flush panel mount port installed right below the seat heat switch and for the rear seat mount on left side by switches
-
I use their wireless setup. I have the mail controller available under seat to connect to liner and the wireless controller attached to the left handlebar. Easy install.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|