Results 1 to 6 of 6
  1. #1
    Active Member johnv50's Avatar
    Join Date
    Jun 2018
    Location
    Tonawanda, NY
    Posts
    214
    Spyder Garage
    0

    Default I finally broke down and bought a manual, all is ok

    I need to replace a right-side saddlebag latch. Anyone who has performed this repair that can give me some help??
    I should probably buy a shop manual unless there is a free one somewhere on this site.

    thanks johnv
    Last edited by johnv50; 11-25-2022 at 04:25 PM.
    USMC RETIRED

    BLUE KNIGHTS NYV

    2022 F3T Glacier Blue

  2. #2
    Very Active Member Jetfixer's Avatar
    Join Date
    Feb 2016
    Location
    Lake Wylie, South Carolina, USA
    Posts
    1,040
    Spyder Garage
    2

    Default

    You have to remove the saddlebag from the bike. After that is very easy and obvious to replace the latch. Remove the top cover and you'll see the screws that hold the saddlebag to the frame. It is basically hanging on rails and after removing the screws and the plastic pushpin at the bottom it will slide outward and off. There's a disconnect for the taillight.

    side view.jpg saddlebag.jpg latch.jpg
    Last edited by Jetfixer; 11-26-2022 at 07:07 AM. Reason: added photos
    2020 RT Limited Deep Marsala Chrome

    2020 RT Limited , Marsala Red

  3. #3
    Active Member johnv50's Avatar
    Join Date
    Jun 2018
    Location
    Tonawanda, NY
    Posts
    214
    Spyder Garage
    0

    Default

    Thank you for the reply Jetfixer. I finally broke down and bought a manual. It was a fairly easy job, now the wait on parts. Do you by chance know how to replace the keylock ??.

    thanks johnv
    USMC RETIRED

    BLUE KNIGHTS NYV

    2022 F3T Glacier Blue

  4. #4
    Very Active Member Jetfixer's Avatar
    Join Date
    Feb 2016
    Location
    Lake Wylie, South Carolina, USA
    Posts
    1,040
    Spyder Garage
    2

    Default

    Quote Originally Posted by johnv50 View Post
    Thank you for the reply Jetfixer. I finally broke down and bought a manual. It was a fairly easy job, now the wait on parts. Do you by chance know how to replace the keylock ??.

    thanks johnv
    That's a little tricky. At the end of the key barrel furthest from the key, there is a locking tab. Put the key into the barrel and leave it at the unlock position. From the interior (lower) side, you may have a small cover to remove to gain access to this locking tab. You'll need to use a small pick or flat blade screwdriver to push down on the locking tab and then remove the key barrel. When you reverse this procedure to install the key barrel on a new latch handle, make sure that this locking tab "clicks" into place. This photo is from a RT service manual, but the lock barrels are the same.


    key barrel.jpg
    2020 RT Limited Deep Marsala Chrome

    2020 RT Limited , Marsala Red

  5. #5
    Active Member johnv50's Avatar
    Join Date
    Jun 2018
    Location
    Tonawanda, NY
    Posts
    214
    Spyder Garage
    0

    Default

    Thanks again Jetfixer, I was able to swap the old barrel into the new lock.

    johnv
    Last edited by johnv50; 11-27-2022 at 12:56 PM.
    USMC RETIRED

    BLUE KNIGHTS NYV

    2022 F3T Glacier Blue

  6. #6
    Active Member johnv50's Avatar
    Join Date
    Jun 2018
    Location
    Tonawanda, NY
    Posts
    214
    Spyder Garage
    0

    Default

    As it turns out you can purchase the latch assembly for about $35. It comes pre-assembled and is a very easy install. Anyone who needs to replace the latch contact me via a PM and I will gide you through the procedure.

    thanks Johnv
    Last edited by Peter Aawen; 12-09-2022 at 12:45 AM. Reason: Removed extraneous CR...?!?
    USMC RETIRED

    BLUE KNIGHTS NYV

    2022 F3T Glacier Blue

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •