-
Very Active Member
Need hints for installing throttle body
Did a valve clearance check. 1st in 14yrs and 30,000 miles. All was ok
Now having great difficulty in refitting the throttle body into the 2 rubber inlet sleeves. They seem flexible enough.
All hints will be gratefully received.
Done it.
Opened the 2 clamps to their max. Applied a little grease to lips of the throttle body mouths and used a fine screwdriver to guide the rear one in. They just popped in then.
Last edited by oldgoat; 09-29-2022 at 04:44 PM.
2008 GS SM5, Full Moon Silver
2007 Piaggio MP3 - 250cc
-
Very Active Member
Some lubrication on the rubber? I have used a dab of liquid soap when mounting carbs on multi cylinder bikes. Dries and doesn't harm anything.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|