What options to replace driver foot pegs for Floorboards?

[USAF]

What floorboards are you guys replacing your driver foot pegs with? This will be on a 2012 RTs. Will later year OEM floorboards work or does this have to be aftermarket?

Thanks!

[Eviltwin]

I made a set for my 2010. I think the options on the older bikes may be getting a bit sparse. Here is what I did: https://www.spyderlovers.com/forums/...ore-(Many-Pix)

This was about 4 years ago and they are still holding up fine.

[CopperSpyder]

from one of our sponsors https://store.valueaccessories.net/footpegsmisc.aspx

[Arachnerds]

We have a 2011 that had pegs but we wanted floorboards too. There were nice looking 6 1/4" long ones from Lamonster ..... https://www.lamonstergarage.com/comm...-rt-lamonster/ .....but we went with some longer ones from Pierre at canamspyderaccessories.com https://www.canamspyderaccessories.c...-rhino-lining/ We also ordered the "floating" highway pegs at the same time. Love both!

[Tatonka]

If anyone sees any Kuryakin Widow pegs..rsvp

[Tatonka]

Any of those floor boards work with a manual trans?
Some time ago I found some for my 13 RT but after mounting I found I couldn’t get my toe down to initiate the shift. So I have a peg on the shifter side and a board on the brake side which works out quite well.