-
Found this in my Spyder RT (What is it?)
Hey, as some of you are aware, I just bought a 2018 Spyder RT Limited Dark. It came with a cover in the rear center trunk and I pulled it all the way out and found the thing in the attached pictures inside of it. I was wondering if y'all could help me figure out what this is exactly? Doesn't seem to fit anywhere obvious. Looks like it has a 2-screw mounting point, but then also has a gasket for a seal around the edge. Also has 2 circular velcro stickers on the backside of it and I don't see anything that matches any of these. Would appreciate some of the expert eyes to take a look and let me know. Thanks.
PXL_20220617_183622840.jpg
PXL_20220617_183628925.jpg
PXL_20220617_183639544.jpg
PXL_20220617_183648058.jpg
-
Very Active Member
I wish the picture of it was here on site!!!
-
Originally Posted by Mikey
I wish the picture of it was here on site!!!
lol, yeah I know. It didn't upload right the first time. I edited immediately after and redid the upload and it worked the second time around.
-
Very Active Member
I don't have that year Spyder but it looks like a battery cover to me. My battery cover has those velcro dots to hold a plastic sleeve with the BRP roadside assistance information in it. On a 2022 RTL it is behind the frunk liner.
2022 Petrol Metallic RT Limited / 'PYDER'
Peter Pan has struck again!
-
Very Active Member
Good luck!!
-
Originally Posted by FrogmanDave
I don't have that year Spyder but it looks like a battery cover to me. My battery cover has those velcro dots to hold a plastic sleeve with the BRP roadside assistance information in it. On a 2022 RTL it is behind the frunk liner.
Didn't think to unzip the cover on the battery, but you're right on! I just tried it out and that's exactly where it's supposed to go. Thanks!
Now to get it back on there. Only 1 screw is in there right now, so gonna have to find a match somewhere to get it back on there securely. Appreciate it! Have a good one.
-
Looks like the frunk door at the bottom. Covers the battery. Should have two screws to hold it in place. The velcro is for the frunk liner to hold it.
Looks like you figured it out..
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|