Cleaning the inside of instrument cluster?

[WillieB]

I have a moisture stain on the inside of my instrument cluster ( 2015 F3s ) caused by condensation. Have any of you opened the cluster to clean the inside of the lense? I am guessing there are a few out there with the same issue. Your ideas, suggestions and pictures would be greatly appreciated.
Willie

[Wmoater]

It looks like there’s a lens in front of the cluster that can be removed. Part 349a. I bet if there is moister its on that lens not inside the actual gauge. Dash would need removed. Watch Pierre’s videos on how to replace/remove the dash.

[Gedge]

I have replaced the acrylic cover and not that hard to do. After removing the cluster, there are a few tabs around the outside, use a small screwdriver to release tabs and it will pull off. When cleaned just snap back on

[WillieB]

Thank You, Wamoter, I will watch the videos.

[WillieB]

Thank You, Gedge, I will pull the cluster and do the same.����

[Isopedella]

Newbie question.

Where do I find these Pierre’s videos?

Edit. Stand down, think it found them and ya know that blokes looks vaguely familiar haha.

Bookmarked for later viewing .