-
Help. Ryker Rally rear shock bolt removal problems
Ok looking for anyone who remove rear shock and had issues with the 16mm "gold" bolt that holds the pivot arm. I'm trying to remove rear shock , and have it down to this one bolt. Tried wrenching it with breaker , 1/2 inch impact so far won't budge. I'm soaking it now with "liquid wrench" and gave a few whacks with small hand sledge to help.
I'll go back in a few hrs and try again, but wondering short of heating it if any one had and solved this problem.
-
Try a 36" piece of pipe on the end of the breaker bar.
-
Very Active Member
Originally Posted by CsOldGrayDog
Ok looking for anyone who remove rear shock and had issues with the 16mm "gold" bolt that holds the pivot arm. I'm trying to remove rear shock , and have it down to this one bolt. Tried wrenching it with breaker , 1/2 inch impact so far won't budge. I'm soaking it now with "liquid wrench" and gave a few whacks with small hand sledge to help.
I'll go back in a few hrs and try again, but wondering short of heating it if any one had and solved this problem.
You have discovered a well known fact about how much Lok-Tite BRP uses, ..... try heating with a soldering Iron... and use a longer bar ..... good luck .... Mike
-
Originally Posted by gbatown
Try a 36" piece of pipe on the end of the breaker bar.
I'm a strong believer in using leverage issue in this case is space, with ryker on jackstands most I have is about 24inches for a short space. I have put max bar I could fit but applying arm to that is hard,but I'll keep trying that.
-
Yep pulling the other bolt, nut off I saw half inch of what ever yellow glue they had so liberally put on. I'll try and post a picture, but doubt any soldering iron will heat the bolt from one end to the other. But I'll look at some online and see what I can find.
4 bolts to remove shock, of course I get 1 with a problem.
Last edited by Peter Aawen; 05-01-2022 at 09:00 PM.
Reason: Of course - ;-)
-
hair dryer or heat gun will help
-
Let us know how you make out.
-
So we start with the problem bolt
20220503_162242.jpg
then we use propane and impact wrench
20220503_162459.jpg
and finally
20220503_162250-1.jpg
That is not rust thats half inch of thread locker! Took way more heat than you would guess, but it's really in a big heat sink.
Now have to get the shock out, and Elka in, fun never stops on installs.
Yes that aluminum foil, and red spray can is fire extinguisher ATGATT means safe!
-
So with work and mothers day just got back to this.
last item if you do this switch, loosen the spring pretension screws all the way. I could not get old shock out, until I did that, but after loosening it slid right out.
Need to bolt the Elka in, but it's sitting where it needs to go now.
20220510_184835.jpg
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|