Installation of Garmin XT - which acc circuit for key on hot?
Just got my 2022 F3-L and want to install my Garmin XT. I want the GPS
to come on with the key. I found 3 customer accessory circuits, 1 in the
trunk 1 under the left access panel and 1 under the passenger seat.
Question is does anyone know if they are always hot or
do they come on when the key is turned on? Or is there a different way
to connect it? Thanks for any help.
I connected my Zumo XT on the accessory circuit under the left panel. Works great.
Rick
2019 F3 base
Shad saddlebags with Admore led light kit
BajaRon swaybar
Hopnel mini bra
BRP driver's backrest
Madstad windshield
Ultimate floorboards
CanAm Spyder accessories rear shelf with LinQ adapter
The are hot with the engine running only, not with the key on. I just installed my Zumo XT using the one under the left side panel. Good Luck!
Yep same wire used here, its a bit annoying that it only works when the engine is running rather than just having the ignition on but at least the XT has a reasonable battery. The one on my 590 used only last a couple of minutes.
In my 2018 I found the customer accessory in the frunk have power only whit the engine running.
So I used the one in the left panel under the seat. It has power whit the key on.
WillieB is correct my 2018 F3 limited only has power when the engine is running using the one under the left panel. I originally thought it worked with the key on, because the I always started the engine.
Last edited by rjinaz86323; 04-22-2022 at 09:43 AM.
All three connections are hot only when the engine is running.
Not in mine. The one in the frunk is hot whenn the engine is running but the one on the left side under panel is hot with key on. I'm sorry but i didn't test the third.