-
Accessory lights on 2016 F3 not working! Any suggestions?
I hooked up Led strip light to the accessory cable in my frunk, started Spyder they did not work. The lights are good tested them. Any suggestions on what can be wrong, lights are from a Spyder dealer.
-
Very Active Member
I remember something about having to put a fuse in or change something?
2015 F3 sm6, Custom Dynamics fender lights.
Sea Doo GTI-SE 90 Jet Ski!!
-
Originally Posted by sunflower
I hooked up Led strip light to the accessory cable in my frunk, started Spyder they did not work. The lights are good tested them. Any suggestions on what can be wrong, lights are from a Spyder dealer.
Double check your Neg-Ground connection or ON-OFF switch if you have it wired that way.
-
Very Active Member
LEDs are polarity sensitive and will not work if +/- is reversed. Check the polarity.
Ours is a red, black and chrome 2017 F3 Limited. Bought new in 2/2019. The avatar is my first bike back in 1952, a Simplex Servi-Cycle. Photo taken at the Barber Museum.
-
Very Active Member
Check the voltage at the ends of any of the 3 customer accessory terminals.
The terminal in the frunk of my F3T is working and powers my insignia light.
Where is the 2017 F3T Customer Accessory Circuits fuse location?
Looking at the battery from the front of the Spyder with the frunk liner out its the sixth Spade fuse from the top left in the left-hand fuse box.
Are all 3 Accessory circuits wired to the same fuse or fused independently?
All 3 Accessory circuits share the same fuse and only receive power with engine running so would be no good for a battery tender.
What is/are the total watts available for accessories?.
Fuse is 10 Amp so approx 120 watts.
David C
2016 F3T
DIY Garage Door Opener & GPS Mount
Battery tender cable
Rear IPS Pack Rack
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|