-
Very Active Member
Wrapmyspyder vinyl install ?
OK .. I'm pondering getting some wrapmyspyder frunk stripe/knee panel pieces to change up the look of my F3-S . The install videos make install look quite easy. Is it really that easy? Thanks
2022 RT Sea To Sky
--------------------------------
-
Active Member
I have installed several items from Wrapmyspyder over the years and it is not difficult. The key is to follow the install directions to the letter to get a professional looking result.
My new ride is a 2017 F3-L: BRP drivers backrest, F4 21" tinted shield w/vent, Lamonster fog lights, TRCLED cyclops light, red/black carbon fiber tank protector and dash kit from Wrap-My-Spyder, FOBO tire pressure monitors and more farkles to come.
-
Very Active Member
Originally Posted by troop
OK .. I'm pondering getting some wrapmyspyder frunk stripe/knee panel pieces to change up the look of my F3-S . The install videos make install look quite easy. Is it really that easy? Thanks
I think the hardest part might be getting the surface prep right so that it is smooth and has no residual wax buildup. Don't want the new design to go flying off.
-
Not hard but not the easiest thing you have ever done.Take your time and follow directions and you will be very happy with the results!!Make sure they are where you want them before you start sticking them down.
-
Active Member
, it's not too hard, especially with a couple of extra hands to help you. As with most things, planning and preparation are key. Just take your time.
Skip H.
'21 Can Am Spyder F3 S
'97 Honda Goldwing w/Hannigan Astro 2+2 sidecar
[img]
-
Originally Posted by troop
OK .. I'm pondering getting some wrapmyspyder frunk stripe/knee panel pieces to change up the look of my F3-S . The install videos make install look quite easy. Is it really that easy? Thanks
Yes, I think so. I'm all thumbs but did it okay. Watch and follow the steps in their video.
2014 RTL Platinum
-
Active Member
Not quite hard, but make sure, you clean the surface with alcohol, to get the sticky part to stick... place them with the backing still on, postionthem with some adhesive (painters) tape, peel of half the backing, and just use common sense.
Nowadays the stickers are very forgiving, and use a heat gun (moderate heat), to crimp the vinyl, when you are happy with the result.
Looking forward to see the end result, I have the carbon kneepads from wrapmyspyder, and they fit, and look awesome
the funniest thing about this particular signature is that by the time you realise it doesn't say anything it's to late to stop reading it........
Spyder F3s 2019 All Black ( Named it: Brutus)
Carbon Items added, just for looks
Upgraded Shocks Trac-Tive, Rear hi/lo and rebound adjustable, with Hydraulic Pre-Load adjuster
fronts hi/lo and rebound adjustable, custom made by the Trac-Tive Guru's
Swaybar (Ron's)
Tyres Front Michelin Cross Climate+ 175/60-15
Rear, for 2022 still a Kenda, next Yokohama Advan Fleva 205/55R15
Exhaust Bone stock, with a RLS Cat- Delete
Custom ECU-Mapping, rewritten/adapted to my Ridingstyle
Pedalbox, Awesome Upgrade...
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|