Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    Jun 2021
    Location
    Georgia
    Posts
    26
    Spyder Garage
    0

    Default RT622 Lids and adjustment - any easy way to adj the front lid?

    Anyone know of an easy way to adjust the front lid on a rt622? Previous owner had the removed the lids to paint the trailer. sort of got them back on but huge gap was between front and rear lid. Attempted to adjust the front and got it almost perfect as far as the panels fitting the gap .. having trouble with the front latch.. used paper for pressure template to get the pin located, adjusted but just can't seem to get the lid to smoothly open and close. Anyone have special tricks?

  2. #2
    SpyderLovers Sponsor cptjam's Avatar
    Join Date
    Jul 2010
    Location
    Las Vegas, NV
    Posts
    3,850
    Spyder Garage
    0

    Default

    1. Lots of lube in the latch. Slather in wd40, then dust with powder. Close lid. The powder will scrape off where it is not aligned. Now loosen the hinge bolts, adjust, repeat.
    2. Once it is positioned properly, clean and lube. Tighten bolts.
    3. Do the other lid the same way. Takes a bit of time, but well worth it! Joe
    Last edited by cptjam; 08-09-2021 at 01:31 AM.
    Joe Meyer



    Dealer for the Outlaw/ROLO laser Alignment system

  3. #3
    Member
    Join Date
    Jun 2021
    Location
    Georgia
    Posts
    26
    Spyder Garage
    0

    Default

    Quote Originally Posted by cptjam View Post
    1. Lots of lube in the latch. Slather in wd40, then dust with powder. Close lid. The powder will scrape off where it is not aligned. Now loosen the hinge bolts, adjust, repeat.
    2. Once it is positioned properly, clean and lube. Tighten bolts.
    3. Do the other lid the same way. Takes a bit of time, but well worth it! Joe
    Thanks, didn't think of that...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •