I am attempting to install a cruise control on my Ryker. I am tapping into the throttle wires. Below see a schematic of my wiring. This is a roster 250-1882. I am using magnets for vss. Everything seems to work fine until I plug the yellow wire from cruise control (ecu circuit 2,) to the bikes throttle sensor 2 + (yellow/red wire).
It throws the bike into limp home mode.
Any ideas what I am doing incorrectly?
Last edited by Peter Aawen; 07-25-2021 at 09:14 PM.
Reason: a see atta tic... = schematic? ;-)