handlebars question - anyone changed out bars to bring closer to rider?

[budvoss]

Has anyone changed out the handlebars on their ryker to bring them back closer to operator ? . I need about two inch's closer.
thanks all

[fatboy]

i put the stock f3 bar on wifes 2021 rt she happy

[AZCanAm]

https://can-am-shop.brp.com/on-road/...osition-a.html

[CopperSpyder]

You see the photo of the Spyder in Budvoss avatar. but the question is post in the Ryker area so handlebars for a Ryker.

[budvoss]

You see the photo of the Spyder in Budvoss avatar. but the question is post in the Ryker area so handlebars for a Ryker.

Thanks, i fixed it to say ryker..Thank you

[Tslepebull]

Has anyone changed out the handlebars on their ryker to bring them back closer to operator ? . I need about two inch's closer.
thanks all

I switched to the Ryker Cross Style bars. they are several inches wider and about a fist higher and a fist further back. Really improved my comfort.

[canamryder]

I added the 2" risers by Rox Speed to my Ryker Rally. I did tilt the risers back about 45 degrees also. Rox offers different sizes also. Don't go too long, the electrical harness is only so long. I unclipped the wiring from my handlebar.
PRO: No drilling out new handlebars and converting everything over.
CON: have to slide handlebar forward for fueling.

https://www.youtube.com/watch?v=bMPLhplv6BE
https://www.youtube.com/watch?v=iwRbzKmuNHE
https://www.amazon.com/Rox-Speed-FX-...s%2C186&sr=8-9

[budvoss]

I added the 2" risers by Rox Speed to my Ryker Rally. I did tilt the risers back about 45 degrees also. Rox offers different sizes also. Don't go too long, the electrical harness is only so long. I unclipped the wiring from my handlebar.
PRO: No drilling out new handlebars and converting everything over.
CON: have to slide handlebar forward for fueling.

https://www.youtube.com/watch?v=bMPLhplv6BE
https://www.youtube.com/watch?v=iwRbzKmuNHE
https://www.amazon.com/Rox-Speed-FX-...s%2C186&sr=8-9

Thanks , I believe i will try this setup u used..
thanks

[Vincef329]

Replaced stock with Renthall low road bars. Exactly the cruiser feel I was looking for, a little higher and 2-3 inches back.

[Quickdraw]

I bought the wife a new set of bars from Renthal.

[microrogue]

It is ok to drill into aluminium bars?

[Pantera]

It is ok to drill into aluminium bars?

Yes, it will be okay to drill aluminum bars.

[sKiZo]

Be sure to de burr, eh.

I highly recommend using a deburring tool for the holes. Just pop it in and the blade cleans any sharp stuff both inside and out. Especially important for wires, and a great investment for the shop at around $10 at most any big box hardware.

[Spygoat]

I drilled into the ProTaper bars I put on the wife's Ryker without issue. I also de-burred the holes.

ryker bars.jpg

[jfuselier]

I added the Z-Bars. They bring the grips up and back. (I don't know why the pic is upside down. Can't get it to rotate)

[Spygoat]

(I don't know why the pic is upside down. Can't get it to rotate)

I thought maybe you were in Australia...lol