-
Will an original Ryker wheel nut socket fit the recall/replacement wheel nuts?
I've been reading a lot about Ryker wheel nut sockets. Can someone tell me if I have an original wheel nut, will a socket that fits that nut also fit a replacement/modified nut - are they the same size?
Last edited by Peter Aawen; 04-17-2021 at 12:07 AM.
Reason: Title clarification
-
Ozzie Ozzie Ozzie
As I understand it, the replacement wheel nuts are effectively an original wheel nut with a section cut out of one lug - so YES, a socket that fits the original wheel nuts should fit the replacement/upgraded wheel nuts!
2013 RT Ltd Pearl White
Ryde More, Worry Less!
-
SpyderLovers Sponsor
BRP recommends a 65mm socket. However, I found that a 2-1/2" socket is a better fit. The 65mm is loose, too much of a gap which puts more pressure on a smaller contact patch with the nut. At 221 pound ft. force, that's well less than ideal. Get the 2-1/2" socket. It is a better fit, they are easier to find and less expensive too.
I've got a brand new 65mm socket, cheap! If anyone wants it.
Shop Ph: 423-609-7588 (M-F, 8-5, Eastern Time)
Only SLOW people have to leave on time...
-
Very Active Member
I have used my 2&1/2 inch Klutch brand socket from northern tools to remove and re-torque both front and rear wheel nuts on my Rally model. The socket worked fine before and after the nuts were recalled and only cost about $21.
-
SpyderLovers Sponsor
Originally Posted by Tslepebull
I have used my 2&1/2 inch Klutch brand socket from northern tools to remove and re-torque both front and rear wheel nuts on my Rally model. The socket worked fine before and after the nuts were recalled and only cost about $21.
Yes, the nut dimensions have not changed. Just (Hopefully) better quality control. Not all the original nuts were failing. Just some. Again, quality control issues. There are many reasons why Chinese products are less expensive. One is that they generally do little or no quality control. That saves a good deal in production costs.
Essentially, they let the end user do the quality control portion of the process. BRP had the same issue with their plastic end links about 10 years ago. Most held up fine. But they discovered that 1 batch were failing at a pretty good clip. Fortunately, they were able to identify the bad batch and did not have to replace all of them. I think it can happen in any production process.
Shop Ph: 423-609-7588 (M-F, 8-5, Eastern Time)
Only SLOW people have to leave on time...
-
Very Active Member
23 Moto Guzzi V7-850 SE 23 Yamaha XT250 18 Yamaha Bolt R-Spec 22 Triumph Street Twin 20 CanAM Ryker 900 14 Honda CB1100 18 Yamaha XT250 16 Moto Guzzi V7 II 17 Yamaha TW200 12 Triumph Bonneville 02 Sportster 1200 Sport 03 Sportster 883 76 Honda CB750F 75 Honda CB360 70 Yamaha CT1 72 Yamaha CT2 72 Yamaha AT2/CT2 70 Honda SL350 70 Honda CL350 67 Honda CL160 67 Honda CB160 62 Honda CA110
2020 900 , NGK 4218 iridium CR8EIX Matte black
Forum
Can Am Ryker
Will an original Ryker wheel nut socket fit the recall/replacement wheel nuts?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|