Plastic clips for flags

[SpyderConvert]

It seems that I have lost both of the plastic clips that hold the small flags on the trunk mounts on my '15 RTL. Does anyone have any idea where I may get replacements?? TIA!!

[trikermutha]

https://www.motorcycleid.com/cruiser...ers-signs.html

Page down till you see the clips.

I am sure other places sell them too.

https://www.rivcoproducts.com/shop/i...indian/fh201a/

[IdahoMtnSpyder]

What I did was put a stainless steel washer below the flag held in place by a snug O-ring. This lets the flag move freely around the shaft and keeps it from sliding down. In fact, if you watch closely you'll see the flags fly backward much of the time as the air whips around the Spyder.

[pegasus1300]

I also used a snug "o" ring and a plastic water bottle cap with a hole cut in it. Keeps the flag from falling down and I put another on top to keep flag from pulling up over the top.

[IdahoMtnSpyder]

I also used a snug "o" ring and a plastic water bottle cap with a hole cut in it. Keeps the flag from falling down and I put another on top to keep flag from pulling up over the top.

That's right, I have a washer at the top also.

[SpyderConvert]

Thanks for the replies!! I went with the "o" rings, but haven't ridden yet to see if they work. $3.45 each for the plastic clips????!!!!