20210302_135756 (2).jpg20210302_135710 (2).jpg20210302_135227 (2).jpg20210302_135041 (2).jpg20210302_135024 (2).jpg20210302_134610 (2).jpg20210112_103918 (2).jpg20210108_135403 (2).jpg20210108_134724 (2).jpg First made a cardboard mockup out of cardboard of hand guard then bought a 3' length of aluminum flat stock(1/8" x 2"). Cut to length and bend in jig, round off ends, drill holes and paint. Spacer was a 1" hockey puck drilled out with a hole saw. Hardware used was button head M6 x 20mm on the end of the handle bar and M4 x 60mm thru the spacer. Haven't tried them yet because there is still snow on the ground but they are only 2" wide so they don't block the mirrors sight, but should block rocks or other road debrie.