-
Looking for Caps to cover 4 bolts on handlebar
Does any one know to cover the four bolts holding down the handle bars? I'm looking for chrome or black caps to cover them.
Last edited by Peter Aawen; 01-29-2021 at 07:44 AM.
Reason: Removed Prefix - this is a 'How do I?' not a 'How to:' DIY explanation....
-
Originally Posted by Warfels
Does any one know to cover the four bolts holding down the handle bars? I'm looking for chrome or black caps to cover them.
Go to your local ACE Hardware store, look in the nut&bolt section drawers for them.
-
Very Active Member
David C
2016 F3T
DIY Garage Door Opener & GPS Mount
Battery tender cable
Rear IPS Pack Rack
-
Very Active Member
I've had these on all my rides since I discovered them . Ace hardware I think. I think the look of the hex bolts on the bars is ugly without them. They are all over my poor ,old,slow V-Max too.
PS:
Hey Dave---- got time for a ride today??? Oh wait------ FEET of snow at my house. Not a foot either. If I hadn't cleared the drifts in front of the garage I'd have 6 feet there.
Lew L
Kaos----- Gone but not forgotten.
2014 RTS in Circuit Yellow, farkle-ing addiction down to once every few months. ECU FLASH IS GREAT.
-
-
Active Member
Thanks for the lead on the bolt covers. On my 2020 it looks like lock-tite was splashed all over the bolts. It will be nice to cover them up.
-
I use LamonsterGarage IPS nut caps. The set is 6 and I have yet to figure out what to do with the extras.
IMG_1240.jpg
-
I found 3/4 inch covers in Lowes. They fit loosely so I put a little clear caulking to keep them in place. If I fined 16 MM covers (size of blot head) I'll replace them. The ACE HW I went to didn't even have any bolt protector covers
IMG_1149.jpg
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|