I just installed a new sway bar on my new to me 2015 RT yesterday. I got a lot of guidance from a youtube video by Can-Am Spyder Accessories. In the video the installer suggested spraying "a little white grease" on the grommets that hold the snap on panels in place thus making it easier to remove these panels next time. When I changed engine oil a month ago I lubed the grommets with a little shot of Windex and everything glided back into place smoothly but I removing a couple of those same panels yesterday and it was a struggle.
The question is, should I follow the video tip and put a grease on the grommet and probably collect dirt or just leave it factory dry and threated to break off panel tabs with each removal.
You folks on this forum have lots of practical experience that I might as well tap into, even if my question is pretty trivial.