-
What is the Ryker Front Wheel hub bore size?
Does anyone know what the hub bore size is for the Ryker front wheels?
-
Very Active Member
I just went out to the garage and measured the exterior of the hub on mine; it is 1.75 inch. The bore size (for the wheel) should be slightly greater. The inside bore of the hub appears to be 1.5 inch.
-
Very Active Member
Assuming you need that info for wheel balancing cones, Marc Parnes sells these on their "Spare Parts" page: http://www.marcparnes.com/Motorcycle...Components.htm
COMBI Cone set for single-sided rear wheels on all Ducatis, 2010 and older Triumphs, MV Augusta, VFR as well as Spyder front wheels bored for a 1/2" shaft.
Still needs the shaft & bearings to complete the kit.
'20 Spyder RT: Bajaron swaybar. Vredestein tires, Pedal Commander, Elka front shocks, GPS/USB/12V handlebar mount, Heli-Bars, Radar Detector, KOTT grills & vents, Shad top case, chin & DRL LEDs.
-
Nice to know that my VFR cones will work for the Spyder wheels. I'm thinking I'll need a longer shaft for the rear wheel though.
Need to do some measuring.
Peggy and Howard
Hers: 2013 Spyder ST-S SM5
His: 1999 Honda VFR Interceptor
-
Very Active Member
Yes. get the long shaft. The standard length is too short.
-
Originally Posted by Tslepebull
I just went out to the garage and measured the exterior of the hub on mine; it is 1.75 inch. The bore size (for the wheel) should be slightly greater. The inside bore of the hub appears to be 1.5 inch.
Thanks! And yes I am trying yo balance them. But the page that is provided appears to be for a hand spin type balancer set up. I will be using an electronic spin balancer.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|