I have searched through the forum and I've read through the manual and cannot find how to obtain the active codes on my 2018 Spyder RTL. So I hope someone can help without telling me to do the obvious so far.

Lamonster's video shows him pressing MODE and SET and pushing in the turn signal buttons at the same time, but on the 2018 there's not a SET button. there's a home button and no combination I've used with it seems to work.

twice now while on a ride my engine light started flashing and it went into LIMP mode. I turn the bike off, wait a few minutes, turn it back on and it does still have the engine light flashing and LIMP mode come back on, but then both clear within a few seconds.

How can I figure out what the problem is?