-
Active Member
removing BRP lower belt guard.........how?
OK, nothing critical and sounds stupid I know, but......... what I found was that the 3 nuts (that you can't see or actually hold) are spinning while I'm turning the bolt head.
Don't think getting a wrench up in there to hold the nut is possible. If so, what size wrench/socket fits?
I'm looking to add a few washers to bring the "plastic" out a little because it does appear it has lightly rubbed the belt/sprocket edge at some time.
appreciate any insight.
Ray & Marci
Tenino, WA
2014RTL Cognac
ALWAYS ride 2 up.
-
Oh yeah those are a pain. Try lifting the bike up a bit to get your hand and wrench in there. I think its 10MM. Think only one of them had a washer to keep the plastic away from the belt.
-
Very Active Member
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|