Heated Pass. Handholds - are all F3's pre-wired?

[Poasttown]

Are the F3 series of spiders without heated passenger handholds wired to accepted the heated handholds?

Poasttown

[jwulf74]

Not sure about the F3 and F3S... but I know my wifes F3T is...

[BLUEKNIGHT911]

Are the F3 series of spiders without heated passenger handholds wired to accepted the heated handholds?

Poasttown

I can't personally say the F-3 is " pre-wired ", but I would be very, very surprised if it wasn't ..... WHY ???? - Ford , GM, Chrysler etc. only make one " wiring Harness " for each separate model.... It's the only economical way to do it.... This makes building a car much simpler ..... I have found " capped wire harnesses " in my Basic model RT. The Basic doesn't have all the bells and whistles but the wiring is there if needed during assembly .... hope this helps .... Mike

[Poasttown]

The reason for my asking. If other spiders have the wiring in place, to add heated handholds, they must have some form of end cap on these plugs. If this is true then I would like to purchase these end caps so I can cover my electrical plugs due to me removing my electric handholds.

I’m currently using electrical tape which I’m sure is fine but this has become somewhat of a challenge. If and or when I get an answer I will post the info.

Poasttown

[KenInMN]

If it turns out that they are pre-wired I will be putting the set on my 2018 up for sale. They have to be removed for the OEM passenger armrests.

[Rattlebars]

Pull the seat. It will have the 2 pin connector with a cap. Under the buttons by the key it will also have the connector for the control.
heatplg.jpg