-
Member
2019 Spyder RT Limited with LED's & Hyperflash - any fixes?
I installed LEDs in the rear turn signals and now hyper flash. I tried the LaMonster thing, no go. Tried to hold the e flasher button down for 45 seconds, no go. Any suggestions? Is there a separate flasher for the rear turn signals?
-
Very Active Member
Did you try it with the engine running?
For some reason that made the difference on my cousins when I installed the LEDs on his.
Held down Eflash button for roughly 30 sec, saw the dash lights flash once when the reset took place and all was good to go.
-
Member
I didn't have the engine running, just the key on. Will try it.. Thanks...
-
Member
-
Active Member
After your 45 seconds are up, release flasher, turn on left or right turn signal for ONE FLASH and turn ignition off immediately. Same procedure on opposite side.
-
Active Member
I have a 2018 RTL and when I put LED bulbs in rear turn signals I had the same problem. Went through all the e flasher procedures without luck. Has to put resisters in line to stop hyper flash.
-
Different companies now make LED bulbs with build in resisters...No splicing or soldering...
I like these...https://www.lasfit.com/
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|