Results 1 to 3 of 3

Thread: Help please!

  1. #1
    Member
    Join Date
    Jun 2017
    Location
    Missouri
    Posts
    20
    Spyder Garage
    0

    Default Help please!

    I have a 14 Spyder ST SE5. Just replaced the battery since I figured it was getting old. Went out to start it and turned the key on and nothing happened, no lights on dash, no headlights but the alarm when you don’t put parking brake on went off and wouldn’t stop for over two hours. I checked all the smaller fuses and they are good but haven’t checked the relays. Battery at posts tests good and is fully charged. Any help is much appreciated.

  2. #2
    Very Active Member Bfromla's Avatar
    Join Date
    Aug 2014
    Location
    Bossier LoUiSiAna
    Posts
    5,978
    Spyder Garage
    1

    Default

    Polarity correct & terminals tight? You say checks good, what is that voltage? Was battery load tested? Try again & slowly go over start up procedures; key, kill switch, brake applied (park brake on or not) SE5 funny like that.

    2013 STL SE5 BLACK CURRANT
    SpyderPop's: LED bumpskid
    SmoothSpyder: dualmode back rest
    T r * * LED:foam grip covers, Tricrings, FenderZ,
    brake light strips, wide vue mirrors
    Rivico SOMA modulation brake leds
    sawblade mowhalk fender accents
    minispyder dash toy
    Lid lox
    KradelLock
    Pakitrack
    GENSSI ELITE LED H4 headlights
    FLO (Frunk Lid Organizer)
    BRP fog lights, trailer hitch
    SENA 20S EVO
    2013 STL , Stock Stock Black currant

  3. #3
    Member
    Join Date
    Jun 2017
    Location
    Missouri
    Posts
    20
    Spyder Garage
    0

    Default

    Quote Originally Posted by Bfromla View Post
    Polarity correct & terminals tight? You say checks good, what is that voltage? Was battery load tested? Try again & slowly go over start up procedures; key, kill switch, brake applied (park brake on or not) SE5 funny like that.

    Yes battery was load tested. The trike was rode up after battery was replaced with no Issues. The polarity is correct. The screen and everything doesn’t come on. Didn’t know if there was a main fuse somewhere that I’m not seeing. I checked the fuses in the frunk and all looked good but didn’t test or check relays.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •