Results 1 to 5 of 5
  1. 05-25-2020, 12:51 AM #1
    Allan
    Allan is offline
    Member
    Join Date
    Dec 2015
    Posts
    2
    Spyder Garage
    0

    Default F3s front drive belt sprocket

    I have a f3s and have done 42000 km and in that time I have stripped two drive sprockets does any one else have the same problem or am I too had on the bike
    Cheers
    Allan
    Reply With Quote Reply With Quote
  2. 05-25-2020, 01:02 AM #2
    Bottomline2000
    Bottomline2000 is offline
    Active Member
    Join Date
    Aug 2019
    Location
    TX
    Posts
    87
    Spyder Garage
    0

    Default

    Are you using a belt tensioner?
    Reply With Quote Reply With Quote
  3. 05-25-2020, 01:05 AM #3
    Allan
    Allan is offline
    Member
    Join Date
    Dec 2015
    Posts
    2
    Spyder Garage
    0

    Default

    No I use the cricket to get belt tension correct
    Reply With Quote Reply With Quote
  4. 05-27-2020, 04:58 AM #4
    stu
    stu is offline
    Active Member
    Join Date
    Jul 2016
    Location
    australia
    Posts
    152
    Spyder Garage
    0

    Default

    Make sure theres no freeplay between the shaft splines and pulley splines,fit pulley with a spline loctite.use the latest high grade bolt and upgraded tension for the bolt.you should be ok.
    Reply With Quote Reply With Quote
  5. 05-27-2020, 09:07 PM #5
    Freddy
    Freddy is offline
    Very Active Member Freddy's Avatar
    Join Date
    Dec 2009
    Location
    West Oz
    Posts
    907
    Spyder Garage
    1

    Default

    https://www.spyderlovers.com/forums/...ket-Inspection
    The best substitute for brains & knowledge is....................silence.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules