Rox risers on 2020 RTL

[troop]

I'm considering adding the Rox risers also. It looks like the Rox clamps are slightly wider apart than the oem clamp where it holds the actual handle bars . I have a GPS mount that uses the top two mounting bolts of the original clamp. Are the new bar clamps set further apart? If so I would have to fab a bracket to keep my gps mount.

I have the Spyder***** dual powerport on my OEM bars. The top mounting holes are only 3-1/4" wide. At that width, not only will you not have full range of motion the risers allow, but you also won't have good access to equally tighten down the (4) lower clamp bolts. No go for me..