Any good Cup holders for 2020 RT?

[Pennyrick]

Has anyone found a good drivers cup holder that fits on the 2020 RT?

Pennyrick

[sduskin]

I ordered LaMonster's yesterday after reading a forum post where a rider drilled and tapped the cable shield for a ball mount. LaMonsters comes with a bottle holder.

[bikerbillone]

Interesting, can you post a link or pic? I have problems trying to negotiating Lamonster's web site and finding an item I'm looking for. Thanks.

[CentralCoastCA]

https://www.lamonstergarage.com/can-...lamonster-ips/

Or this one

https://www.lamonstergarage.com/can-...lamonster-ips/

[mrwog]

I had my wife hold my cup while I went riding.... it was not in her hand when I returned..... Haha just kidding just kidding.

[bikerbillone]

Thanks CentralCoast..

[KX5062]

The Lamonster one looks like a really nice piece of kit. However, it also looks like with the short bars on the stock 2020 RT the drink cup holder might get in the way.

[NEXUS]

Finding a place to put a cup Holder on the 2020 RT was a little bit limited.
I found a place and a way to get it out of the way and still be accessible.

Where I ended up putting it at works just fine but it's a little complicated to do
but doable for most anybody. If you want to step-by-step instructions send me
a PM

Cost from GPSCity.com was $41.00 which is free shipping. Add another
$4.00 for the screws and locking nuts from Lowe's.

I put one on both sides. While I had it off, so the cost is for two mounts
as you can see in the pictures. I may use the other one for camera mount later.

20200409_172020.jpg

20200409_172059.jpg

20200409_162256.jpg

20200409_162243.jpg

[mr z]

I use a Butler Cup. Works great.

[samewok]

I use the top cuff from Lamonst

[scooterexpress]

Has anyone found a good drivers cup holder that fits on the 2020 RT?

Pennyrick

glassact.com

[Pennyrick]

Finding a place to put a cup Holder on the 2020 RT was a little bit limited.
I found a place and a way to get it out of the way and still be accessible.

Where I ended up putting it at works just fine but it's a little complicated to do
but doable for most anybody. If you want to step-by-step instructions send me
a PM

Cost from GPSCity.com was $41.00 which is free shipping. Add another
$4.00 for the screws and locking nuts from Lowe's.

I put one on both sides. While I had it off, so the cost is for two mounts
as you can see in the pictures. I may use the other one for camera mount later.

20200409_172020.jpg

20200409_172059.jpg

20200409_162256.jpg

20200409_162243.jpg

Thanks for the response as well as the PM with more details. Much too in involved for me. Kind of like building a watch to tell the time but appreciate your efforts.

Pennyrick

[ARtraveler]

We bought a pair last OCT at the Green Country Jamboree in OK. They were from a place called Diamond R Accessories. They fit nicely on on 2014 RT and 2011 RT. I changed out the one from my 2011 and put it on the new 19 F3. I am thinking the 2020 set up is similar. Diamond R should know. Two longer screws replace the ones that are standard on the right hand side handlebar control panel. Took me all of five minutes to make the change out.