-
Belt tension
What is the current recommended belt tension for a 2015 f3s ?
-
Very Active Member
Recommended by who ???? .... Most folks here have had great success with 150-160 lbs using a KritKit ... measured " on the ground ". I use this and have none to very, very little vibes ..... Mike
-
Very Active Member
Originally Posted by BLUEKNIGHT911
Recommended by who ???? .... Most folks here have had great success with 150-160 lbs using a KritKit ... measured " on the ground ". I use this and have none to very, very little vibes ..... Mike
I dropped my F3-L tension to around 155lbs, based on Mike’s experience, and then removed my aftermarket tensioner that was showing signs of wear. Vibration is now virtually non existent, so dropping the BRP recommended tension worked for me, too.
Pete
Harrington, Australia
2021 RT Limited
Setup for Tall & Big.... 200cm/6'7", 140kg/300lbs, 37"inleg.
HeliBars Handlebars
Brake rubber removed to lower pedal for easier long leg/Size 15 EEEEW boot access.
Ikon (Aussie) shocks all round.
Russell Daylong seat 2” taller than stock (in Sunbrella for Aussie heat & water resistance)
Goodyear Duragrip 165/60 fronts (18psi) - provides extra 1/2” ground clearance.
Kenda Kanine rear.
2021 RT Limited , Brake pedal rubber removed for ease of accessing pedal with size 15 boots. Red
-
-
Are you suppose to measure the tension from the top if the belt down or the bottom of the belt up? Thanks!
-----
Joshua
2012 Victory Vision
2016 Spyder F3S
2019 Spyder RT Limited
-
Active Member
What is the recommended cricket measurement for the old RS (2010) belts while on the ground? I should check mine. Thanks. Nevermind, found an old thread that said 160-180 for my RS. Thanks.
-
Top of belt down in the middle of span
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|