What's the extra Switch on the 2020 RT Limited for?

[Peter Aawen]

page modified ...ok now

Nope, at least not for me!? Now it says 'FORBIDDEN'

[ThreeWheels]

Just a further update:
I moved into a new house recently and replaced the crappy old garage door openers with newer Genie ones with DC drive and battery backup.
The new openers would not read the signal from my MoDoor remote.
Since I had four remotes, I took a chance at soldering wires to the board of one of the new remotes.
I'm surprised, but happy to report that I was successful and the door goes up and down with a press of the button on the panel, as shown in my previous post.
https://www.spyderlovers.com/forums/...=1#post1551078

[Spiderfrog]

I installed the Spyderpops garage door opener in the place of the blank. I have the BRP auxiliary light (it is plugged and play) no switch needed, comes open with engine start.

[SpyderStro]

I know this is an old thread, but what's the thoughts on this aux light? Good or so so?

[KX5062]

I know this is an old thread, but what's the thoughts on this aux light? Good or so so?

I bought an aftermarket LED light for under $20 that fit almost perfectly with slightly better output, so I can't comment on the OEM light, but honestly it doesn't do all that much. It is a little bit better at illuminating the road at night right in front of you and a little better daytime visibility to other drivers. So, for me at under $20, it was worth it, but at the cost of the OEM, I doubt it. However, only you can decide.

[ThreeWheels]

Just an update, I think I've published this before. I replaced the blank switch with a an additional OEM windshield switch that I've wired up to a garage door opener.
This spring, I also rearranged the switches into a more pleasing view, with both of the switches that control the heating gear together in the center.
The garage opener is now in the upper right.

[fatboy]

i put marine usb with volt meter in the spare hole

[FrogmanDave]

Just an update, I think I've published this before. I replaced the blank switch with a an additional OEM windshield switch that I've wired up to a garage door opener.
This spring, I also rearranged the switches into a more pleasing view, with both of the switches that control the heating gear together in the center.
The garage opener is now in the upper right.

I did exactly the same except my switch is from Mo-Door. It is plain black and only has one momentary position. The center console looks much better with the heat switches together in the center. It should have been this way from the factory.