-
License Plate Access
I got my handicap license plate, but cannot figure out how to access the nuts on the bolts through the plate holder. There is insufficient clearance between the rear fender/extension to get a wrench in there. It would appear I have to remove the fender extension, but I don't see how. The manual diagram shows the extension attached with two plastic rivets, but there is some kind of interlocking mechanism. Just removing these is insufficient. Its a 2019 F3L.
Anyone know how to get to the license plate nuts?
-
Very Active Member
It's a pain in the ass. Have a new 18 F3L. Used a box end on inside socket outside. Got started by hand then used wrenches. Had to pull the back fender out as far as i could by hand. Thought it was going to break but i got it. It can be challenging and a must have patience Good Luck
-
My wife’s Spyder I used a 10 mm deep 1/4 inch sockets and a torex bit on the outside.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|