Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    Jul 2019
    Location
    California
    Posts
    26
    Spyder Garage
    0

    Default License Plate Access

    I got my handicap license plate, but cannot figure out how to access the nuts on the bolts through the plate holder. There is insufficient clearance between the rear fender/extension to get a wrench in there. It would appear I have to remove the fender extension, but I don't see how. The manual diagram shows the extension attached with two plastic rivets, but there is some kind of interlocking mechanism. Just removing these is insufficient. Its a 2019 F3L.

    Anyone know how to get to the license plate nuts?

  2. #2
    Very Active Member bmccaffrey's Avatar
    Join Date
    Oct 2013
    Location
    rome new york
    Posts
    2,221
    Spyder Garage
    0

    Default

    It's a pain in the ass. Have a new 18 F3L. Used a box end on inside socket outside. Got started by hand then used wrenches. Had to pull the back fender out as far as i could by hand. Thought it was going to break but i got it. It can be challenging and a must have patience Good Luck

  3. #3
    Active Member
    Join Date
    Sep 2019
    Location
    Cold Lake Alberta
    Posts
    44
    Spyder Garage
    0

    Default

    My wife’s Spyder I used a 10 mm deep 1/4 inch sockets and a torex bit on the outside.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •