Depending on what is holding it together it may be as simple as turning the little red markers and holding the inside with your finger or a tool. Sometimes they are rusty and you may need WD40 to loose them up. It should be very simple process.
Is there anything holding it on other than a screw and nut? Should be just two screws, two nuts. As Oldtimer51 mentioned, the screws may have Red Markers for a head.
2011 RTS (Sold to a very nice lady)
1998 Honda Valkyrie
2006 Mustang GT. Varooooom!
US Navy Veteran
SC Law Enforcement Boat Captain
CNC Machine Service Technician
President: Rolling Thunder SC1
Member: Disabled American Veterans, Rock Hill, SC
Member: American Legion
Experience is recognizing the same mistake every time you make it!
Depends what year. I think the 2020s have to have the lower rear fender removed to access the nuts. Could be he's trying to get a temp tag off a new byke.
OP--you may need a deep well socket to remove the nuts from behind. I know I had to.
license plate mounting
Reply With Quote
