-
How to connect tail lights?
I am adding a rear trunk to my 2008 Can Am Spyder GS. It has tail lights, turn signals and brake lights built into it.
How/where do I safely connect them to the Spyder’s wiring?
-
Very Active Member
Originally Posted by JerryofWV
I am adding a rear trunk to my 2008 Can Am Spyder GS. It has tail lights, turn signals and brake lights built into it.
How/where do I safely connect them to the Spyder’s wiring?
If this is a " DIY " mod, I did similar to my 08 GS and my 11 RSS ….. I accessed the main rear connections and after identifying what each wire was doing ( ie stop, turn, run etc. ) I just added my lights to that circuit …..I added LED type lights, and tow hitch wiring for a trailer …… good luck … Mike
-
Thanks Mike. I didn’t think I could just tap into the wires. I was afraid that would mess with the computer system.
-
Very Active Member
Originally Posted by JerryofWV
Thanks Mike. I didn’t think I could just tap into the wires. I was afraid that would mess with the computer system.
Well it didn't on the GS, RSS or 2014 RT ….. Mike
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|