How to connect tail lights?

[JerryofWV]

I am adding a rear trunk to my 2008 Can Am Spyder GS. It has tail lights, turn signals and brake lights built into it.

How/where do I safely connect them to the Spyder’s wiring?

[BLUEKNIGHT911]

I am adding a rear trunk to my 2008 Can Am Spyder GS. It has tail lights, turn signals and brake lights built into it.

How/where do I safely connect them to the Spyder’s wiring?

If this is a " DIY " mod, I did similar to my 08 GS and my 11 RSS ….. I accessed the main rear connections and after identifying what each wire was doing ( ie stop, turn, run etc. ) I just added my lights to that circuit …..I added LED type lights, and tow hitch wiring for a trailer …… good luck … Mike

[JerryofWV]

Thanks Mike. I didn’t think I could just tap into the wires. I was afraid that would mess with the computer system.

[BLUEKNIGHT911]

Thanks Mike. I didn’t think I could just tap into the wires. I was afraid that would mess with the computer system.

Well it didn't on the GS, RSS or 2014 RT ….. Mike