-
Active Member
2018 F3L wolo bad boy horn mounting?
Wife bought this horn from spyder pops because when I’m in front of her I can’t even hear the dinky stock horn. Anyway after I already tried mounting with the instructions we found out it is for pre-2017 bikes. Anyway, surely somebody has successfully mounted one of these. Looking for help before we return it. Thanks
Mine: 2016 Indian Springfield & 2021 Indian Roadmaster
Wife: 2018 Can-am Spyder F3 Limited Pearl White
-
SpyderLovers Sponsor
Don’t return it! Use the mounting metal straps from the stock horn. Drill the holes out big enough to pass the bolt through. We clip the zip tie to loosen up the wire. Hang the horn. Remove the plastic from the A arm. Trim the plastic so it fits. Reinstall the plastic. Done! Joe
Joe Meyer
Dealer for the Outlaw/ROLO laser Alignment system
-
Active Member
Thank you for the reply! Do you have a pic? I thought I tried fitting it there.
Mine: 2016 Indian Springfield & 2021 Indian Roadmaster
Wife: 2018 Can-am Spyder F3 Limited Pearl White
-
Active Member
Sounds like I was trying to put it on the inside of the bracket where the stock one was, sounds like I need to try it on the outside?
Mine: 2016 Indian Springfield & 2021 Indian Roadmaster
Wife: 2018 Can-am Spyder F3 Limited Pearl White
-
Member
IMG_4045.jpg I mounted a Stebel on the LH side of my 2016 F3L. Had to cut away some of the plastic to provide the needed clearance, but its not visible from the outside.
-
Active Member
On my 2018 F3 Limited, the Wolo sits in the same position/area as the stock horn, though higher up. There is just enough space for the horn. I made a custom bracket from 1/8" x 1" flat mild steel (with a 45 degree twist) that uses the same mounting holes as the original horn bracket. The photo shows the horn by the R/H chassis arch and inboard of the R/H upper A-arm.
PC013030.jpg
-
SpyderLovers Sponsor
No picture, but will take one the next time I do one.
Joe Meyer
Dealer for the Outlaw/ROLO laser Alignment system
-
Active Member
Well I finally got it mounted yesterday, I forgot to get a picture as well. I will get one though. I was able to mount it where the existing horn was, used the L bracket from the original horn and used the aluminum bracket that came with the horn. Had to cut one end off and trim it down some but was able to install it. Thanks for all the feedback from everyone and making me give it another try. My main concern before was it getting in the way of steering or suspension components, but since a lot of you put it there without any issue I went for it, ha.
Mine: 2016 Indian Springfield & 2021 Indian Roadmaster
Wife: 2018 Can-am Spyder F3 Limited Pearl White
-
Active Member
A little guidance and perseverance made it happen for you. GOOD JOB! Now you've got a horn with... AUTHORITY.
-
Very Active Member
I mouned a pair of OEM GoldWing horns in the cavern behind the grill. They will wake the dead without all the hardware. On >ON MY PAGE click here< I give detailed instructions about mounting and wiring with a simple auto relay.
basic-horn-relay.gif
gl-horns.jpg
-
Active Member
Are you just plug and play on the walo with the stock relay or do you need to add additional parts?
-
SpyderLovers Sponsor
Joe Meyer
Dealer for the Outlaw/ROLO laser Alignment system
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|