Wanted to share my experience in installing Can-Am armrests. Bought mine at Central Florida Powersports via Amazon for about $311 total. I used Shawn Smoaks' video for guidance, and am forever indebted for his help. Things went about as planned except for 2 things....The 4 holes need to be drilled to accommodate the new screws for the armrest, and I realized that you should start all the new screws before tightening any of them completely, as the one in the back is at a weird angle, and it almost tried to strip.
Further, under no circumstances would I be able to remove the antenna, and had to release the screw that was holding it in, which allowed me to finally release the panel adjacent to the speaker housing. This was the most time consuming issue of the project. A fair amount of Loctite was present I suspect.
The job took about 3 1/2 hours total, and I'll add a picture and whether it makes my wife more comfortable on the back or not.
Further, under no circumstances would I be able to remove the antenna, and had to release the screw that was holding it in, which allowed me to finally release the panel adjacent to the speaker housing. This was the most time consuming issue of the project. A fair amount of Loctite was present I suspect.
The job took about 3 1/2 hours total, and I'll add a picture and whether it makes my wife more comfortable on the back or not.
