Page 3 of 3 FirstFirst 123
Results 51 to 67 of 67
  1. #51
    Active Member
    Join Date
    Jul 2018
    Location
    Fountain Hills,AZ
    Posts
    336
    Spyder Garage
    0

    Default

    So in laymans terms ...don't put back any of the 2 red wires and check small red wire for voltage... ground black multi to frame of bike?

  2. #52
    Very Active Member Gwolf's Avatar
    Join Date
    Apr 2019
    Location
    Florida Swamp
    Posts
    1,935
    Spyder Garage
    2

    Default

    Quote Originally Posted by wilpir View Post
    So in laymans terms ...don't put back any of the 2 red wires and check small red wire for voltage... ground black multi to frame of bike?

    You are not trying to find out what power is on the solenoid. It is like a heavy duty switch for the large cable from the battery to the starter. What you are trying to find out is if the two large posts, which would normally have the heavy cable attached to them, are opening and closing. In order to make the switch open and close the power is 'applied to/removed from' the smaller wires. To test that you measure the continuity across the two large posts. No power to the small wires, should mean no continuity measured across the large posts. Power applied to the small wires, should mean there is now continuity measured across the large posts. You should hear a definite click when it cycles. There is no reason to have either of the heavy wires hooked to the solenoid. You are only trying to determine if it is opening and closing. When the solenoid is wired to the starter and in the circuit, then it is acting as a switch and the starter case is grounded. Having the starter disconnected (heavy wires not connected to solenoid) will let you test the solenoid without danger of damaging the starter gears or burning up the wiring.

    If you find that there is always an open circuit across the two large posts (not very likely), then test the voltage of the small wires.

    If you find that there is always continuity from large post to large post, no matter if voltage is applied to the smaller wires or not, that means the solenoid is not functioning as a switch. It is stuck closed and is always a dead short leading from the battery to the starter.

    The solenoid points inside the case could have become welded. If that is the case the solenoid is broken and must be replaced. It is pointless to attempt to get it working again. Even if you could break it loose and get it to open and close, the contact points would still be severely pitted and it would not be 100%. There is also a spring inside the case which should open the points when no power is on the electromagnet. If the spring is broken the solenoid is worthless. The case is sealed. The parts inside the case are not repairable. Throw it away and put a new one on.

    2019 F3-S , Black & Silver

  3. #53
    Active Member Eviltwin's Avatar
    Join Date
    Oct 2017
    Location
    Portsmouth VA
    Posts
    366
    Spyder Garage
    1

    Default

    That is an excellent diagram. Hope the OP understands how it works. I'm not sure how much more layman I could make the explanation.
    2019 BMW C650GT, 2010 Spyder RT-S, 2009 BMW R1200RT,(sold) 2009 Honda Silverwing (Sold), 2009 Kawasaki 500 Vulcan (Sold)

    \
    2010 RT SE5 , Black

  4. #54
    Very Active Member Gwolf's Avatar
    Join Date
    Apr 2019
    Location
    Florida Swamp
    Posts
    1,935
    Spyder Garage
    2

    Default

    Quote Originally Posted by Eviltwin View Post
    That is an excellent diagram. Hope the OP understands how it works. I'm not sure how much more layman I could make the explanation.


    Yeah, that is just about as layman as I can possible make it.
    2019 F3-S , Black & Silver

  5. #55
    Very Active Member Revalden's Avatar
    Join Date
    Nov 2018
    Location
    Claremore, Ok.
    Posts
    683
    Spyder Garage
    1

    Default

    Quote Originally Posted by Gwolf View Post
    Yeah, that is just about as layman as I can possible make it.
    That is the best possible diagram possible, for layman or expert.
    2015 RTS SE6 Special Series Red/Black w/Magnesium front fenders(bought in Nov. 2018 w/9,400 miles)
    Dynojet Power Commander V, Power Commander POD-300 Display, PCV Map Switch, Pedal Commander (WOW)
    Passenger Arm Rests, Windshield Air Wing
    Baja Ron's Sway Bar & Spring Adjusters
    Air Scoops, LaMonster's Hiway Pegs
    Magnetic Mirror Mounts, Air Innovations Seat Cushion
    Red Chrome pin striping on Black hood
    Federal Formoza AZ01 front tires (they're GREAT)
    Kumho Ecsta AST KU25 All-Season Tire - 225/50R15 91H
    LED bars above radiator inlets
    LED brake/running/turn signals on license plate frame
    Tag-Along trailer
    LED headlights LED fog lights (WOW)
    2" x 2" Road Lights inside front fenders
    7' x 10' Cargo trailer
    Garmin 396 LM GPS
    RLS Cat-delete resonator with China Akropovic muffler
    New Banshee AGM
    M3 TPMS on front tires
    Remote Control for Heated Jacket and Heated Riding Pants
    Analog Clock and Analog Volt Meter
    Loose Nut Behind Handlebars
    2015 RT-S Special Series , Stock Spark Plugs Brake Pedal Extension Cherry Red/Black

  6. #56
    Active Member
    Join Date
    Jul 2018
    Location
    Fountain Hills,AZ
    Posts
    336
    Spyder Garage
    0

    Default

    yep..replaced starter solenoid and all is right..Thanx Guys!!!

  7. #57
    Very Active Member Grandpot's Avatar
    Join Date
    Oct 2014
    Location
    Fort Mill, SC
    Posts
    1,951
    Spyder Garage
    0

    Default

    Thank you for letting us know the outcome. Sounds like it was an inexpensive fix if you did it yourself.
    2011 RTS (Sold to a very nice lady)
    1998 Honda Valkyrie
    2006 Mustang GT. Varooooom!
    US Navy Veteran
    SC Law Enforcement Boat Captain
    CNC Machine Service Technician
    President: Rolling Thunder SC1
    Member: Disabled American Veterans, Rock Hill, SC
    Member: American Legion
    Experience is recognizing the same mistake every time you make it!

  8. #58
    Very Active Member Bfromla's Avatar
    Join Date
    Aug 2014
    Location
    Bossier LoUiSiAna
    Posts
    5,977
    Spyder Garage
    1

    Default

    Quote Originally Posted by wilpir View Post
    yep..replaced starter solenoid and all is right..Thanx Guys!!!
    now about the brake failure message that preceded

    2013 STL SE5 BLACK CURRANT
    SpyderPop's: LED bumpskid
    SmoothSpyder: dualmode back rest
    T r * * LED:foam grip covers, Tricrings, FenderZ,
    brake light strips, wide vue mirrors
    Rivico SOMA modulation brake leds
    sawblade mowhalk fender accents
    minispyder dash toy
    Lid lox
    KradelLock
    Pakitrack
    GENSSI ELITE LED H4 headlights
    FLO (Frunk Lid Organizer)
    BRP fog lights, trailer hitch
    SENA 20S EVO
    2013 STL , Stock Stock Black currant

  9. #59
    Active Member
    Join Date
    Jul 2018
    Location
    Fountain Hills,AZ
    Posts
    336
    Spyder Garage
    0

    Default

    Quote Originally Posted by Bfromla View Post
    now about the brake failure message that preceded
    Gone!

  10. #60
    Very Active Member Gwolf's Avatar
    Join Date
    Apr 2019
    Location
    Florida Swamp
    Posts
    1,935
    Spyder Garage
    2

    Default

    Good deal.............
    2019 F3-S , Black & Silver

  11. #61
    Active Member
    Join Date
    Aug 2019
    Location
    Glendale, AZ
    Posts
    44
    Spyder Garage
    0

    Default

    Starter solenoids are like big relays. I've had them stick. Sometimes smacking them w/ a hammer will unstick them. It's only temporary but usually it'll get you home.

  12. #62
    Very Active Member Bfromla's Avatar
    Join Date
    Aug 2014
    Location
    Bossier LoUiSiAna
    Posts
    5,977
    Spyder Garage
    1

    Default

    Quote Originally Posted by wilpir View Post
    Gone!
    good to hear sorry all other troubles in between, hopefully saved you from a fail somewhere on the road like out of state trip &. Good idea to go ahead & document all you can for any possible future troubles. So you can share with a tech if need be. It was a unusual fluke & worth the notes.

    2013 STL SE5 BLACK CURRANT
    SpyderPop's: LED bumpskid
    SmoothSpyder: dualmode back rest
    T r * * LED:foam grip covers, Tricrings, FenderZ,
    brake light strips, wide vue mirrors
    Rivico SOMA modulation brake leds
    sawblade mowhalk fender accents
    minispyder dash toy
    Lid lox
    KradelLock
    Pakitrack
    GENSSI ELITE LED H4 headlights
    FLO (Frunk Lid Organizer)
    BRP fog lights, trailer hitch
    SENA 20S EVO
    2013 STL , Stock Stock Black currant

  13. #63
    Active Member
    Join Date
    Jul 2018
    Location
    Fountain Hills,AZ
    Posts
    336
    Spyder Garage
    0

    Default

    Well the brake fail screen came on again!! Im not going to even mess with it ..taking it to the dealer..hope its a quik fix..have to wait another week for an appointment

  14. #64
    Active Member
    Join Date
    Jul 2018
    Location
    Fountain Hills,AZ
    Posts
    336
    Spyder Garage
    0

    Default

    Well just got back from dealer...They said air in system, worn rear brake pad ..they reset system , changed rear brake pads, replaced crush washers, changed and bled brake fluid..at a cost of $511 OUCH!! Live and Learn...

  15. #65
    Very Active Member Bfromla's Avatar
    Join Date
    Aug 2014
    Location
    Bossier LoUiSiAna
    Posts
    5,977
    Spyder Garage
    1

    Default

    Quote Originally Posted by wilpir View Post
    Well just got back from dealer...They said air in system, worn rear brake pad ..they reset system , changed rear brake pads, replaced crush washers, changed and bled brake fluid..at a cost of $511 OUCH!! Live and Learn...
    They say anything about why the other issue occurred?

    2013 STL SE5 BLACK CURRANT
    SpyderPop's: LED bumpskid
    SmoothSpyder: dualmode back rest
    T r * * LED:foam grip covers, Tricrings, FenderZ,
    brake light strips, wide vue mirrors
    Rivico SOMA modulation brake leds
    sawblade mowhalk fender accents
    minispyder dash toy
    Lid lox
    KradelLock
    Pakitrack
    GENSSI ELITE LED H4 headlights
    FLO (Frunk Lid Organizer)
    BRP fog lights, trailer hitch
    SENA 20S EVO
    2013 STL , Stock Stock Black currant

  16. #66
    Active Member
    Join Date
    Jul 2018
    Location
    Fountain Hills,AZ
    Posts
    336
    Spyder Garage
    0

    Default

    No everything was checked all good now

  17. #67
    Active Member 3Willie's Avatar
    Join Date
    Sep 2010
    Location
    Cape Girardeau, Missouri USA
    Posts
    213
    Spyder Garage
    0

    Default

    Tried the above reset procedure several times without any success. Will try the battery disconnect next to see if that will help.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •