So, you're going to remove some panels and wonder how you're going to keep track of all the hardware(screws and pushpins) and where each goes on reassembly.

Some say bag'm. Well, that works if you know what size(length) goes where. If you don't, heres an easy way to do it until you do know where they go.

Take a pizza box and cut yourself two full size squares from the top and bottom of the box. Label one left, and one right. As you remove each screw, starting at the top left of the square push your first screw through the box(or make a a pilot hole with a small philips driver first). As each screw comes out, orient it to the box like it came from the panel. First panel off, drop down on the box and start on the next panel.

Now, when you're ready to go back together. You know where things go. As far as where the push pins go, they're self explanatory.

Hope this helps someone a little.