-
Active Member
Another zinger for the Spyder engineers......
So, Last week, I finally installed my BRP heated grips onto the bike since I was doing some other wiring mods inside the guts. All was crystal clear and easy except the part where you had to remove the 4 little allen head screws from the bottom of the handle bar covers. Not really mentioned in the instructions or the factory manual. Unless i missed an important step, they were dang near impossible to remove without a whole lot of cuss words even I did not know.
Good work, guys................
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|