-
Active Member
Any Ideas/ Brake Failure
Spyder was fine no problems. Lifted it in the air install Doc vibration damper. Started bike to see how the the damper was tracking on the belt turned it off put panels on. went to go for ride it says brake failure, engine light is flashing, Abs light is lit up and what looks like a bunch of little zzzzzz. Nothing else was done an noway the damper has anything to do with it. Any why this would all of a sudden happen. C006 C0034 C0031 Brake Failure
-
Very Active Member
Happens....
This is common when the spyder is run with the rear wheel in the air as the nanny finds that the front and rear wheels are not spinning near the same speed. You should be able to set her down pull the key and let the computers re-set then ryde it and they will see that all wheels are spinning alike and leave you alone....
Gene and Ilana De Laney
Mt. Helix, California
2012 RS sm5
2012 RS sm5 , 998cc V-Twin 106hp DIY brake and park brake Classic Black
-
Active Member
-
Ozzie Ozzie Ozzie
-
Active Member
Thank you guys. when I sat the bike down I did roll in forward but guess not enough. I thought darn I have some dumb luck, already had brake switch replaced and now this. But you guy were right on the money by the time I got to the end of the driveway it was gone and crisis adverted. Thanks again chalk this up a lesson learned.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|