Hey guys Have a question. My right side mirror on my 2015 ST Limited, Shake a lot, here's a photo of the mirror and it seems to be opening up at the seam. Has anybody had this problem and what can I do? No Magnets for ST's Thank You.
Bottom piece looks like it is in place. The top looks like it is being "pushed" up. Make sure the wiring harness is sitting inside properly. It is a tight fit, but if it isn't laying down correctly, it may be be contributing to the misfit.
Bottom piece looks like it is in place. The top looks like it is being "pushed" up. Make sure the wiring harness is sitting inside properly. It is a tight fit, but if it isn't laying down correctly, it may be be contributing to the misfit.
when I replaced mine with the chrome accents there was not much there to lock in place careful when removing as the springs clips brake all too easily. I believe there were 2 little screws barely accessible behind the mirrors(not 100% sure) will look if I still have the info somewhere. *note did not have to remove mirrors to install, just the wind deflectors* & with yours separated it can get water & dust in around the led blinkers , ya you need to seal & or fix sooner.
Found the info FYI you need to remove the lower 1/2 first; this gives access to the screw holding top 1/2 on. 39FB8CAF-002F-4B41-BA6C-A0F2AC304DD4.jpg6782AA52-102E-4BBC-B7EA-51E9FE79BC33.jpg A84C15D3-EBBF-4FB9-85C9-8BE7890C7E4D.jpg it has a note on pic 3 * “make sure she’ll is well inserted into support screw” P1 is the shell 1 is the support screw: looks like where you’d came off. Hope this helps
Last edited by Bfromla; 05-05-2019 at 04:08 PM.
Reason: *info note & pics
2013 STL SE5 BLACK CURRANT
SpyderPop's: LED bumpskid
SmoothSpyder: dualmode back rest
T r * * LED:foam grip covers, Tricrings, FenderZ,
brake light strips, wide vue mirrors
Rivico SOMA modulation brake leds
sawblade mowhalk fender accents
minispyder dash toy
Lid lox
KradelLock
Pakitrack
GENSSI ELITE LED H4 headlights
FLO (Frunk Lid Organizer)
BRP fog lights, trailer hitch
SENA 20S EVO
2013 STL SE5 BLACK CURRANT
SpyderPop's: LED bumpskid
SmoothSpyder: dualmode back rest
T r * * LED:foam grip covers, Tricrings, FenderZ,
brake light strips, wide vue mirrors
Rivico SOMA modulation brake leds
sawblade mowhalk fender accents
minispyder dash toy
Lid lox
KradelLock
Pakitrack
GENSSI ELITE LED H4 headlights
FLO (Frunk Lid Organizer)
BRP fog lights, trailer hitch
SENA 20S EVO
The Mirrors on the ST are different then the one's on the RT's Clips on RT are on the mirror mount on the ST on the Bike.IMG_20190529_151727.jpgThat' s the new clip I replaced the old one.