Nico 75 - Fitting Ryker Grill Protection

[Nico75]

Hi all just fitted grill protection to 900 Ryker, a few pointers. It's a bit of a struggle to remove the large front (after service cover) two screws underneath, twist and pull sides till loose, then pull panel forward to pull out of rubber grommets. The only part easy is the little EXPENSIVE 6 clips to fit Assembley fit sides back under, but make sure plastic bottom where you took 2 screws out is under frame (I did not) line up plastic with rubber grommets, push forward to make sure plastic is in. Last screw 2 bolts back. NOT a 10 minute job unless you are good at being tough with panels. Regards Nico 75