-
Very Active Member
Replacing seal on brp622
Just received the replacement seals for the 2 lids of the 622 trailer. Question is whether or not there is any adhesive that goes down on lip or does friction hold new seals in place?
2022 RT Limited Dark Hyper Silver
2014 RT-S Pearl White
2010 BRP 622 Trailer Pearl White
-
Very Active Member
NOPE ..................... NO ADHESIVE.
Cruzr Joe
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
-
Very Active Member
If you got the seals from SPYDERPOPS (highly recommended) they will have a "LIP" on them that fits the lids edge.
Cruzr Joe
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
-
Very Active Member
Thank you Joe
I got my seal from a Brp dealer, they are the factory replacement and look to be the same design as what is currently on trailer.
2022 RT Limited Dark Hyper Silver
2014 RT-S Pearl White
2010 BRP 622 Trailer Pearl White
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|