Prosport EVO Series Digital Fuel Level Gauge

[rwk1129]

Anyone successfully installed the Prosport EVO Series digital fuel level gauge on an RT-SE6 (2014)? The gauge has a "selection wheel" on the back where you match the ohm reading of the bike wire that carries the fuel level signal. After installation, the gauge reads 100% regardless of the actual fuel level. Any experience out there?

[pegasus1300]

I would say probably not any experience. The Spyder has a digital fuel gauge once you disconnect the analog gauges. They will then appear on your screen, but you have to disconnect both.

[IdahoMtnSpyder]

Anyone successfully installed the Prosport EVO Series digital fuel level gauge on an RT-SE6 (2014)? The gauge has a "selection wheel" on the back where you match the ohm reading of the bike wire that carries the fuel level signal. After installation, the gauge reads 100% regardless of the actual fuel level. Any experience out there?

Looking at the installation instructions for the EVO and the wiring diagram & service manual of the Spyder your only hope is to see if this works. Put the selector switch on #5 and add a 50 ohm resistor into the wire coming from the level sender. The resistance of the Spyder sensor is 290 ohms empty and 80 ohms full. The EVO #5 is 240 & 33.