|
-
Active Member
 How did you do it?
I am planning to move the BRP Connect from the dash glovebox to the handle bars. For those who have done it, how did you do it? Did you run a new usb into the glovebox and plug it in or pull it out of glovebox, or is there a place on back of display unit to plug into? Inquiring mind would like to know.
-
Very Active Member
run a USB extension from the front box (go thru the rubber liner below the dash) to your handlebars, very quick and easy fix.
Cruzr Joe
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
-
Active Member
That was my plan, just wondering if someone had done it differently.
Thank You! For your response! Cruzr Joe, I think I am going about the same farkles as you have. Short reach handlebars, may I ask how long your arms are? Arm pit to end of center finger. Someone else told me I should get the short reach bars. IPS with Clock?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
Reply With Quote